Hello, you have published in 2012, we are in 2016 and your solution is still working perfectly, congratulations !In fact, I was registered but at the end of 12-13 month period you have to confirm your registration. Which I did, but the system continued to ask my particulars. I had chatted with DS technical support, they knew about the issue but did not know how to solve it, you are better than them !Thank you again
I am having an issue where every time that I open draftsight it asks me to activate and I have entered a few different email address and I have never gotten an email back to activate it! I had our company IT guy install draftsight for as we also use solidworks, but I still get the activation screen! How do I get rid of the activation window?
dwg editor solidworks 2012 crack
Another likely source for this discrepancy was the very thin crack that was found around the region of the stem at the top of the disk (Figure 15). Both of these inconsistencies with the nominal design likely contributed to the resulting higher temperatures as they caused a decrease in the cross sectional area of the current path, thus increasing resistive heating.
In this work, we designed an electrically heated hot spot and measured the temperature over time at the hot spot and a few other points at various temperatures. With Abaqus, we were able to design a test article that was able to produce ignition temperatures. However, because of the repeated heating and cooling of the test article, the disk experienced deformation and eventually cracked, preventing us from performing an ignition experiment with the original disk. In future work, it will be important to consider the effects of deformation on the disk and the repeatability of the experiments. It may be beneficial to design an easier to manufacture test article so that data can be collected with test articles that have only been used a few times, minimizing the effects of the deformation on the resulting temperature. 2ff7e9595c
Comments